Next step is to frame the inside
of the speedbrake doors.
Milled balsa parts are supplied
with the kit. Follow the photos
to install these frames in the
fuselage.
At this stage, do not glue in the
inner cover. Leave the area
open, until the air cylinder and
further detailing are installed in
the door setup.
Use CA glue to glue the frame
in. You might have to reshape
the parts slightly. Make sure
that the frame does not put any
tension on the fuselages skin
in this area, so that the speed
brake door closes smoothly
without any gap.
To Next Page
Loading...
