Cut out the styrene parts and
sand the shape, so that they fit
on the gear doors well. Glue
them on with a few drops of CA
glue.
If you glue only in the top and
bottom center area, you can
later bend the gear door a little,
to get perfectly matching fit in
the wing, and then glue the
rest with CA glue. If you glue
all in one step, you might warp
the door, so that it does not fit
anymore.
Assemble all again, and
double check all again. At that
time you should also take the
inner gear door, which is going
to be mounted at the fuselage,
and hold it in place, to see if
you need to sand some more
of the main gear door in that
area.
Right now you also can glue in
some frame elements, where
this inner gear door will rest
on, when closed.
Next step will be mounting of
the support air cylinder.
To Next Page
Loading...
