Be very careful with the CA
glue on the hinges, as said
before, it makes the plastic
weak. Only apply glue to
the hinge tips. The rest will
be filled with epoxy, after
the correct position is
confirmed.
Finally, when the glue has
set, move the gear doors and
see if they lock anywhere. If
so, sand carefully in this
area, until they move
smoothly.
Glue in the radio
compartment floor and the
top part of the rear nose
gear formaer which will
complete your RC Box.
The front former can be
glued in now, but if you
decide to do a landing light,
leave it out for now.
door
fuselage
point of
rotation
cut out!
To Next Page
Loading...
