Carlin EZ-Temp - User Manual

To Next Page

Microprocessor

Temperature Controls

EZ-Temp

Instruction Manual

Installer/servicer — Except where speciﬁcally stated otherwise,

this manual must be used only by a qualiﬁed service technician.

Read and follow all instructions in this manual and in the appliance

manual. Failure to comply with this or other requirements in this

manual could result in severe personal injury, death or substantial

property damage.

This symbol calls out a hazard that could cause severe personal

injury, death or substantial property damage if the instructions

given are not followed.

Wiring: Refer to EZ-Temp data sheet for wiring information.

Verify ratings: Verify the ratings of the control meet the

requirements of the appliance as speciﬁed in the appliance

instructions. Refer to the EZ-Temp control data sheet for

required electrical supply and load ratings. Verify that the

controls, wiring and installation comply with all applicable

codes.

Electrical shock hazard: Disconnect power to appliance

when wiring or servicing any electrical component.

Scald hazard: Water hotter than 130°F can cause seri-

ous burns or death. Follow water heating appliance

manufacturer’s guidelines when installing temperature

limit controls - DO NOT install a control that can be set

at a higher temperature than speciﬁed. Also verify that

the installation includes all water temperature regulating

means needed to ensure the safety of building occupants,

in compliance with all applicable codes.

Verify operation: Test the controls/appliance to verify the

appliance operates as speciﬁed in the appliance manual

before leaving the installation.

126 Bailey Road North Haven, CT 06473

Phone 203-680-9401 Fax 203-680-9403

Carlin Combustion Technology, Inc.

Tech support 800-989-2275 carlincombustion.com

NEW

PHOTO

NEEDED

Need help?

Do you have a question about the Carlin EZ-Temp and is the answer not in the manual?

Summary

Safety and Installation Precautions

Installer and General Safety Warning

Emphasizes use by qualified technicians and following all instructions to prevent injury or damage.

Hazard Warnings and Wiring Guidance

Explains hazard symbols and directs users to data sheets for wiring information.

Critical Installation Checks and Safety

Covers verifying ratings, electrical shock, scald hazards, and final operation testing.

Sensor and Control Installation

Install Sensor(s)

Detailed steps for installing the EZ-Temp sensor into various types of immersion wells.

Wire the Control

Instructions on routing control wiring through conduit and connecting it to the appliance circuit.

Set the Control

Guidance on setting the limit temperature and testing the appliance operation.