Loosen the screws
10) Loosen the screws at the collars.
11). Adjust the HI-HAT collars to proper height.
12). Screw down to fix the HI-HAT tubes.
.
13). Loosen the butterfly nuts.
14). Adjust the cymbal rod to proper height and angle.
15). Tighten the butterfly nuts.
Loosen the screws
Loosen the
butterfly nuts
16). Loosen the screws at the collars.
17). Adjust the U stand of snare to proper position.
18). Screw down.
To Next Page
