1. Assembly
Caution：
-While adjusting the collar, please take extra care to avoid injury.
-Set the each part to the correct position.
Drum stand assembly
1). Take out the drum stand and loosen the screws of the collars.
2). Set the three master tube at 120°angle.
3). Screw down at the collars.
4). Loosen the screws at the collars.
5). Set the L/R cymbal tubes to the proper height.
6). Screw down to fix the cymbal tubes.
7). Loosen the screws at the collars.
8). Adjust the cymbal collars to proper height.
9). Screw down to fix the cymbal tubes.
Loosen the screws
Screw down
Set the height of the cymbal tubes
Loosen the screws
Assembly steps:
To Next Page
Loading...
