Pad sensitivity
Press the TRIGGER button a third time to enter the sensitivity adjustment S??.
Higher sensitivity value allows the pad to produce a louder volume when played softer.
Lower sensitivity value allows the pad to produce a quieter volume when played harder.
Strike the pad you wish to adjust, use adjustment wheel to change value and press SAVE TWICE
to store.
Pad crosstalk
Press the TRIGGER button a fourth time to enter the crosstalk adjustment c??.
Similar to Threshold, the crosstalk adjustment works for pads that are located closely together,
where close proximity can cause an adjacent pad to mis-trigger. This can be eliminated by setting
a high crosstalk value to the mis-triggering pad.
*note: In most cases this value should not need to change from the factory preset. However if you
do discover a crosstalk issue, the value should only be adjust 1-3 points, as small adjustments
can make a large
difference. You can also consider adjusting the location of the off
ending pads to
create a larger gap between the pads.
Hi-Hat control type selection
Press the TRIGGER button a fifth time to enter the HI-HAT control type selection HH?.
The CSD35M allows you to upgrade your Hi-Hat control to a hardware Hi-Hat stand (available
separately).
HH1 - Included Hi-Hat control pedal.
HH2 - Open/Close hardware stand and stand mount HH CTRL.
19
To Next Page
Loading...
