To Next PageTo Next Page
Need help?Do you have a question about the Carotron Elite Pro Series and is the answer not in the manual?
Instructions for mounting the motor controls for proper airflow and access.
Recommendations for preventing electrical interference and minimizing start-up problems.
Information on AC line inputs, armature power bridge, and required fuses.
Explains field winding connections and polarity considerations for motor hookup.
Describes typical signal connections to the drive, including Emergency Stop and motor thermostat.
Details the HMI display, softkey functions, and navigational controls.
Verifies power supply, connections, and checks for ground faults before operation.
Steps to adjust the velocity regulator using nameplate values and feedback settings.
Procedure for setting up the drive for constant horsepower operation.
Steps to adjust the torque regulator using nameplate values and drive mode settings.
Configuration for Constant Tension Center Winder applications.
Details on adjusting IR compensation, PID gains, and loop tuning for optimal performance.
Explains the Accel/Decel block and its parameters for controlling reference changes.
Details the Velocity PI loop for maintaining desired speed and its feedback mechanisms.
Explains the Current PI loop for regulating armature current or motor torque.
Monitors multiple fault signals for drive protection, shutting down the system upon fault detection.
General