EasyManua.ls Logo

Carp Design V70 - Page 13

Carp Design V70
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
controller will give out the power alarm and the red power indicator of the
boat will begin to flicker. At this time, the boat may enable automatic
returning function in case of lower power. You shall stop using the boat
immediately and charge it.
6The remote controller shall be powered by high-quality AA-sized
batteries such as Nanfu or high-capacity AA-sized charging batteries.
When the power of the remote controller reduces to 30%, the power alarm
will be given out. When the power reduces to be under 10%, please change
the batteries of the remote controller in time. In addition, always make
sure that the remote controller has enough spare batteries for use at any
time. Otherwise, when the power of the remote controller is consumed up,
the boat cannot be controlled and an emergency will occur.
7Before the GPS auto-pilot function is enabled, please make the
right rocker located on the middle position. Manual operation is always
dominant in automatic driving. When you operate the right rocker or press
“Exit” key during automatic driving, the program will terminate and the
boat will switch to the manual operation mode.
8To ensure that the boat keeps within the valid coverage during
sailing the longest distance of the GPS auto-pilot is 300m. The automatic
return is not restricted in case of an emergency.
9If the automatic driving cannot keep the correct direction in the
stormy weather, please switch to the manual navigation mode.
10For the boats install fish finder, please turn off the course
auto-adjust function during the process of finding fish, because the
automatic speed adjustment of the motor may interfere the power supply
voltage of the fish finder.