Carrera Crosscity-E - EC Declaration of Conformity

15
 Having repaired puncture, refit the rear wheel. Take care to ensure the motor cable
is pointing directly downwards to align the anti-rotation toothed washers on the
wheel axle with the dropout slots.
 Firmly tighten both wheel nuts to 40 +/-5 Nm
 Push the two parts of the motor cable connector together, making sure that the
moulded arrows are aligned
 Replace the rubber wheel nut caps & clip the motor cable back under the chainstay.
 Reconnect the rear V brake.
EC Declaration of Conformity