LEGEND
CB — Circuit Breaker
COMM — Communications
HGBP — Hot Gas Bypass
HTR — Heater
LID — Local Interface Device
PSIO — Processor-Sensor Input/Output Module
RB — Relay Board
RBPL — Relay Board Plug
SMM — Starter Management Module
TB — Terminal Board
TEWAC — Totally-Enclosed Water-To-Air Cooled
Denotes Oil Pump Terminal
Denotes Power Panel Terminal
Denotes Component Terminal
Wire Splice
Option Wiring
(FW)
Field Wiring (By Others)
Denotes Male/Female Q.C.
* Denotes Mach. Control Panel Conn.
** Denotes Motor Starter Panel Conn.
Denotes (3) Conductor Connector
Denotes (2) Conductor Connector
→ Fig. 62 — Open Drive — Power Panel
IMPORTANT: Wiring shown is typical and not intended to show detail
for a specific installation. Refer to certified field wiring diagrams.
1141197
To Next Page
Loading...
