SAFETY
CONSIDERA
Installing, starting up and servicing air conditioning
equipment can be hazardous due to system pressures,
electrical components and equipment location (roofs,
elevated structures, etc).
Only trained, qualified installers and service mechanics
should install, start-up and service this equipment
Untrained personnel can perform basic maintenance
functions such as cleaning coils. All other operations
should be performed by trained service personnel.
When working on the equipment, observe precautions
in the literature and on tags, stickers and labels attached
the equipment.
Follow all safety codes.
Wear safety glasses and work gloves.
Keep quenching cloth and fire extinguisher nearby
when brazing.
Use care in handling,
equipment.
rigging and setting buky
See Table I for Physical Data.
ELECTRIC SHOCK HAZARD
Open all remote disconnecas before
servicing this equipment.
Rigging
-
Preferred method is with spreader bars from
above the unit. Use
Z-in.
(50 mm) 0-D. pipe or hooks in
lifting holes. Rig with 4 cables and spreader bars.
Al1
panels must be in place when rigging. See rigging label
on unit for details concerning shipping weights, distance
between lifting holes, center of gravity and spreader bar
dimensions. See Fig. 2.
If overhead rigging is not possible,
place
chiller on skid
or pad for rolling or dragging. When rolling, use mini-
mum 3 rollers. When dragging, pull the pad. Do not ~ppby
force ts
dtze
unif. When in final position, raise from above
to lift unit off pad.
All panels must be in
units if no skid is
supp
P
lace when rigging. Do not fork
ied.
sides only.
If unit has
skid,
truck from
r
WI-IN.
(19
mm) NOTCHES
IN END OR SPREADERS
CENTER 3F
GRAW
Fig. 2
-
Wigging with Spreader Bars
(Field Supplied)
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
PC111 Catalog No.
533-034 Printed
in
U.S.A.
Form
30GT-1
Si
Pg
i
8-aa
Replaces: New
To Next Page
General
