38MGRBQ: Service Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
100
6. Remove the 1 front side panel screw, then remove the front
side panel.
7. Disconnect the fan motor connectors FAN1(3p,white) and
FAN2(3p,white) from the DC motor driver board.
8. Remove the fan motor after unfastening fixing screws.
2 PANEL PLATE REMOVE THE PANEL PLATE REMARKS
1. Remove the 2 handle screws and the 2 water collector
screws.
2. Remove the 2 terminal board screws and 15 right-rear
panel screws, then remove the right-rear panel.
Handle
Screws
Water
Collector
Screws
Terminal Board
Screws
Right-Rear
Panel Screws
Right-Rear
Panel Screws
To Next Page
Loading...
