SG-38MPRA-02 Specifications subject to change without notice. 39
E4/E5/F1/F2/F3 (Open circuit or short circuit of temperature sensor diagnosis and solution)
Description: If the sampling voltage is lower than 0.06V or higher than 4.94V, the LED displays the failure.
Recommended parts to prepare:
• Wiring mistake
• Faulty sensor
• Faulty PCB
Troubleshooting
Fig. 25 —Multimeter
Check the connection between
temperature sensor and PCB.
Replace indoor or outdoor PCB.
Is it within acceptable
parameters?
Is it properly wired ?
Ensure proper connections.
NO
Measure the resistance value
of the sensor.
YES
Replace the sensor.NO
YES
To Next Page
Loading...
