EasyManua.ls Logo

Carrier 38VF014H117010 User Manual

Carrier 38VF014H117010
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
X-POWER Full DC Inverter Outdoor Unit
208~230V
Thank you very much for purchasing our airconditioner, Before using your air conditioner, please read
this manual carefully and keep it for future reference.
Caution: The manual is applicable for the cooling&heating and cooling only outdoor unit. The
cooling&heating indoor unit is applicable for the cooling&heating and cooling only outdoor unit; the
heating capacity of the indoor unit will be effective only when the indoor unit connect to the
cooling&heating outdoor unit.
DATABOOK
/
SERVICE
MANUAL
Question and Answer IconNeed help?

Do you have a question about the Carrier 38VF014H117010 and is the answer not in the manual?

Carrier 38VF014H117010 Specifications

General IconGeneral
BrandCarrier
Model38VF014H117010
CategoryInverter
LanguageEnglish

Summary

Part 1 General Information

1. Features

Details about high efficiency DC inverter compressor and fan motor, smooth sine wave DC inverter.

Part 2 Selection Procedure

2. Unit Selection (Based on cooling load)

Covers given conditions, indoor and outdoor unit selection, and conclusion for cooling load calculations.

Part 3 Specification & Performance

1. Specifications

Details independent unit specifications, including power, capacity, compressor, fan, and coil details.

4. Electric Characteristics

Lists electrical characteristics for various outdoor unit models, including voltage, current, and power.

5. Wiring Diagrams and Field Wiring

Provides wiring diagrams for different HP models and explains field wiring practices.

7. Capacity Tables

Presents detailed cooling and heating capacity tables for various HP models and conditions.

Part 4 Installation

1. Installation Introduction

Covers selection of refrigerant piping, length, level difference, and other piping considerations.

2. Units Installation

Details the installation procedures for indoor and outdoor units, including cautions and base requirements.

3. Refrigerant Pipe Engineering

Explains processing, principles, support, selection, brazing, flushing, and vacuum drying of refrigerant pipes.

8. Commissioning and Trial Running

Explains the procedures for inspection, preparation, trial run of single and parallel systems, and commissioning reports.

Part 5 Troubleshooting

3. Error code table

Provides a comprehensive table of error codes, their content, and corresponding notes for troubleshooting.

4. Troubleshooting

Offers troubleshooting steps for common communication errors (E0, E2) and other system issues.

4.10 P0/P4/H6: High temperature protection

Covers troubleshooting for high temperature protection of the inverter compressor and discharge temperature protection.

4.11 P1: High pressure protection

Details the causes and solutions for high pressure protection, including heat exchange issues and refrigerant excess.

4.12 P2/H5: Low pressure protection

Explains troubleshooting for low pressure protection, addressing refrigerant issues, blockages, and heat exchange problems.

4.13 xP3: Compressor current protection

Provides a systematic approach to troubleshooting compressor overcurrent protection, checking load, condenser, refrigerant, and system air.

4.14 P5: Condenser temperature T3 protection

Guides on troubleshooting condenser temperature protection errors, focusing on sensor issues and system conditions.

4.15 xP6/xH4: Inverter module protection

Details troubleshooting steps for inverter module protection errors like low voltage, high voltage, MCE, zero speed, phase sequence, and frequency differences.

Related product manuals