Example 24 — Using the Schedule Function (cont)
KEYBOARD
ENTRY
DISPLAY
RESPONSE
COMMENT
PROGRAMMING PERIOD 3:
For this example, Period 3 is used on Wednesday only.
OCC 00.00 Start of occupied time
OCC 7.00
Occupied time will start
at 7:00 am
UNO 00.00 Start of unoccupied
time (end of period 3).
For this example,
period 3 should end at
21:30 (9:30 pm)
UNO 21.30
Period 3 ends at
21:30 (9:30 pm)
MON NO Check to be sure that
Monday and Tuesday
are flagged no for
period 3
TUE NO
WED NO Wednesday is flagged
no. Change to yes
WED YES Wednesday is now
flagged yes for
period 3
THU NO Check to be sure that
all other days are
flagged no
FRI NO
SAT NO
SUN NO
HOL NO
Period 4 and 5 can be programmed in the same manner, flagging
Thursday and Friday yes for period 4 and Saturday yes for period 5.
For this example, periods 7 and 8 are not used; they should be pro-
grammed OCC 00.00, UNO 00.00.
NOTE: When a day is flagged yes for 2 overlapping periods, occu-
pied time will take precedence over unoccupied time. Occupied times
can overlap in the schedule with no consequence.
To extend an occupied mode beyond its normal termination for a
one-time schedule override, program as shown below:
OVRD 0
Override is set for 0; enter
the number of hours of
override desired
OVRD 3
Unit will now remain in
occupied mode for an
additional 3 hours
Example 24 — Using the Schedule Function (cont)
KEYBOARD
ENTRY
DISPLAY
RESPONSE
COMMENT
PROGRAMMING PERIOD 6:
For this example, Period 6 is used for holiday only.
OCC 00.00 Start of occupied time
OCC 20.00
Occupied time will start
at 20:00 (8:00 pm)
UNO 00.00 Start of unoccupied
time (end of period 6).
For this example,
period 6 should end at
21:00 (9:00 pm)
UNO 21.00
Period 6 ends at
21:00 (9:00 pm)
MON NO Check to be sure that
Monday through
Sunday are flagged
no for period 6
TUE NO
WED NO
THU NO
FRI NO
SAT NO
SUN NO
HOL NO
Holiday is flagged no.
Change to yes
HOL YES
Holiday is now flagged
yes for period 6
91
To Next Page
Loading...
