40MBAB: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
10
SET FUNCTION
• Press the SET button to enter the function setting, then press SET button or TEMP or TEMP button to select the desired function. The
selected symbol will flash on the display area, press the OK button to confirm.
• To cancel the selected function, just perform the same procedures as above.
• Press the SET button to scroll through operation functions as follows:
FRESH ( ) FOLLOW ME ( ) AP MODE ( )
[*] If your remote controller has Fresh button, you can not use the SET button to select Fresh feature.
FRESH FUNCTION ( ) (some units):
When the FRESH function is initiated, the Ionizer/Plasma Dust Collector (depending on models) is energized and will help to remove pollen and
impurities from the air.
FOLLOW ME FUNCTION ( ):
The FOLLOW ME function enables the remote control to measure the temperature at its current location and send this signal to the air conditioner
every 3 minutes interval. When using AUTO, COOL, or HEAT modes, measuring ambient temperature from the remote control (instead of from the
indoor unit) will enable the unit to optimize the temperature around you and ensure maximum comfort.
AP FUNCTION ( ) (some units):
Choose AP mode to do wireless network configuration. For some units, it will not work by pressing the SET button. To enter the AP mode,
continuously press the LED button seven times in 10 seconds.
To Next Page
Loading...
