@
@-
@
f
6EOFOLLO, MD
__@
-@
_B
Swing _ Button
Used to stop or start horizontal louver move-
ment or set the desired up/down air flow
direction. The touver changes 6 degree in angle
for each press. If keep pushing more than 2
seconds, the louver will swing up and down
automatically.
FOLLOW ME Button:
Push this button to initiate the Follow Me
feature, the remote display is actual tempera-
ture at its location. The remote control will
send this signal to the air conditioner every 3
minutes interval until press the Follow Me
button again. The air conditioner will cancel
the Follow Me feature automatically if it does
not receive the signal during any 7 minute
interval.
N 0 TE:
Buttons design might be slightly different
from the actual one you purchased
depending on individual models.
All thefunctions described are
accomplished bythe indoor unit. If the
indoor unit has no this feature, there is no
corresponding operation happened when
press the relative button on the remote
controller.
11
To Next Page
Loading...
Need help?
General
