f
( R 0SELFOLE
J
(:# <©
(_LEoF0,L0W%
Auto operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Pressthe MODE button to select Auto.
2. Press the UP/DOWN button to set the
desired temperature. The temperature can
be setwithin a range of62°F - 86°F in I°F
increments.
3. Press the ON/OFFbutton to start the air
conditioner.
NOTE
1. In the Auto mode, the air conditioner can logically
choose the mode of Cooling, Fan, and Heating
by sensing the difference between the actual
ambient room temperature and the setting
temperature on the remote controller.
2. In the Auto mode, you can not switch the fan speed.
It has already been automatically controlled.
3. If the Auto mode is not comfortable for you, the
desired mode can be selected manually.
f
SLEEP
_.URB0 SELFCLEA_
(#
FO,,OW 0
Coo|in9 IHeatinglFan operatio.
Ensure the unit is plugged in and power is
available.
1. Press the MODE button to select COOL,
HEAT(cooling & heating models only) or
FAN mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature can
be setwithin a range of62°F - 86°F in I°F
increments.
3. Press the FAN button to select the fan speed
in four steps- Auto, Low, Med,orHigh.
4. Press the ON/OFF button to start the air
conditioner.
NOTE
In the FAN mode, the setting temperature is not
displayed in the remote controller and you are not
able to control the room temperature either. In this
case, only step 1, 3 and 4 may be performed.
13
To Next Page
Loading...
Need help?
General
