What to do if hour figures don't flash when pressing the recessed lock adjustment button on Carrier 42KLE39-E remote?
If the hour figures on the display of your Carrier Air Conditioner remote do not flash when pressing the recessed lock adjustment button, it may be because the button has not been pressed correctly. Press the button with a round point, avoiding strong pressure.
Why do all symbols appear on the display when pressing any button on my Carrier Air Conditioner remote?
When all symbols appear on the display of your Carrier Air Conditioner remote when pressing any button, the recessed button for time setting may be blocked due to excessive pressure during use. Check and repair the button.
What to do if Carrier 42KLE39-E compressor runs but cycles on internal overload?
If your Carrier Air Conditioner's compressor runs but cycles on internal overload, even when the thermostat isn't satisfied, consider these potential causes: there might be too much or too little refrigerant (in which case you should blow refrigerant, evacuate the system, and recharge), or air or non-condensable refrigerant could be in the system (requiring the same solution). Also, the compressor may be defective, or the line voltage might be too low or too high, so replace the compressor and determine the cause. Other possible causes include a blocked outdoor coil (determine and correct the cause), a stopped outdoor fan or defective run capacitor (determine the cause and replace), a faulty fan motor in the outdoor section (determine the cause and replace), or a restriction in the refrige...
General| Star Rating | 3 Star |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Indoor Unit Noise Level | 38 dB(A) |
| Outdoor Unit Noise Level | 52 dB(A) |
| Type | Split AC |
| Heating Capacity | 39000 BTU/h |
To Next Page