GB - 5
42PQV/38VBH
ENGLISH
Material supplied and system charge
The following field-supplied items are required to complete the installation.
Name Specification
009: Ø (3/8”) 9.52 mm (Gas) / Ø (1/4”) 6.35 mm (Liquid)
Connection pipe
012: Ø (1/2”) 12.7 mm (Gas) / Ø (1/4”) 6.35 mm (Liquid)
Wall sleeve
Wall cap
Finishing tape PVC film
Fastening tape
Pipe insulation
Drain hose I.D. 16-17 mm
Sealer putty
- Power supply cable H07RN-F or higher
- Electrical connecting cable
Cable type: H07 RN-F, synthetic rubber insulation with Neoprene coating,
between indoor and outdoor unit
according to EN 60335-2-40 codes.
System charge
Size
Refrigerant Suitable up Maximum pipe lenght Maximum pipe elevation
charge (g) to (m) (m) (m)
009 720 10 10 8
012 1100 15 15 10
1. This appliance is designed to be used without additional refrigerant charge up to 10m for 42PQV009 and 15m for 42PQV012.
There is no need to charge and extract additional refrigerant according to the connecting pipe length within maximum pipe length.
2. In case of refrigerant charging due to refrigerant leak or service, charge exact amount of refrigerant using scale after evacuate the unit
with vacuum pump.
3. For reference, discharge/suction pressure at various temperature conditions and a rated compressor speed are provided service
manual.
Never charge and extract the refrigerant depending on discharge/suction pressure. This unit is inverter system whose compressor
speed is variable.
NAME and shape Q.ty Use
Wall hanging bracket 1 For indoor unit installation.
Screws 4xL10 2 For fixing unit and hanging bracket
Screws anchors and screws 6xL25
4 + 4 + 4 For wall hanging bracket installation.
Washers Ø 12
Drain fitting
1 For drainage of outdoor unit.
Mounting rubber 4 For outdoor unit installation.
Material supplied
The following installation accessories are supplied with unit. Use them as required.
To Next Page
Loading...
