Care and
Maintenance
 
CAUTION
 ● Before changing the lter or cleaning, turn 
off the unit and disconnect its power supply.
 ● When removing lter, do not touch metal 
parts in the unit. The sharp metal edges can 
cut you.
 ● Do not use water to clean the inside of the 
indoor unit. This can destroy insulation and 
cause electrical shock.
 ● Do not expose lter to direct sunlight when 
drying. This can shrink the lter.
Air lter reminders (optional)
Air lter cleaning reminder
After 240 hours of use, the display window on 
the indoor unit will ash “cl.” This is a reminder 
to clean your lter. After 15 seconds, the unit will 
revert to its previous display.
To reset the reminder, press the led button on 
your remote control 4 times, or press the manual 
control button 3 times. If you don’t reset the 
reminder, the “cl” indicator will ash again when 
you restart the unit.
Air lter replacement reminder
After 2,880 hours of use, the display window on 
the indoor unit will ash “nf.” This is a reminder to 
replace your lter. After 15 seconds, the unit will 
revert to its previous display.
To reset the reminder, press the led button on 
your remote control 4 times, or press the manual 
control button 3 times. If you don’t reset the 
reminder, the “nf” indicator will ash again when 
you restart the unit.
 
CAUTION
 ● Any maintenance and cleaning of outdoor 
unit should be performed by an authorized 
dealer or a licensed service provider.
 ● Any unit repairs should be performed by 
an authorized dealer or a licensed service 
provider.
Maintenance – long periods of non-use
If you plan not to use your air conditioner for an
Extended period of time, do the following:
   
Clean all lters
Turn off the unit and 
disconnect the power
Turn on FAN function until 
unit dries out completely
Remove batteries from 
remote control
Maintenance – pre-season inspection
After long periods of non-use, or before periods of 
frequent use, do the following:
Check for damaged wires
Check for leaks
Clean all lters
Replace batteries
Make sure nothing is blocking all air inlets and outlets
 Page 12-GB