EasyManua.ls Logo

Carrier 48GC Series - Page 32

Carrier 48GC Series
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
Table12–SystemVut Controller Alarm Codes
FAULT OR ALERT
ACTION TAKEN BY
CONTROL
RESET
METHOD
PROBABLE CAUSE
F010--- MBB LOW VOLTAGE Unit Shutdown Automatic Brownout condition, low supply voltage, supply power missing a phase.
F011--- MBB REFERENCE VOLTAGE Unit Shutdown Automatic MBB failure or supply voltage low
A012--- MBB ZERO CROSSING Alert Generated Automatic MBB failure or supply voltage frequency to high or too low.
F013--- MBB FUSE 2 OPEN Unit Shutdown Automatic A switch input has a wiring error or the switch pulled too much current.
F014--- MBB FUSE 3 OPEN Unit Shutdown Automatic A switch input has a wiring error or the switch pulled too much current.
A015--- MBB RNET VOLTAGE RANGE Alert Generated Automatic MBB failure or su pply voltage low
A016--- MBB 24VDC RANGE 4-- -20mA inputs will be in error Automatic MBB failure or su pply voltage low
A017--- MBB 5VDC RANGE Transducer inputs will be in error Automatic MBB failure or supply voltage low
F018--- MBB EEPROM FAILURE Unit Shutdown Automatic Software failure or MBB failure
A019--- MBB CLOCK FAILURE No time, date, and schedule
operation
Automatic Software failure or MBB failure
F020--- SOFTWARE ERROR Unit Shutdown Automatic Corrupt Software or software failure
A100--- SAT SENSOR ERROR No free cooling, and no SAT
limit protection
Automatic Faulty , shorted, or open thermistor caused by wiring error or loose connection.
A101--- FST SENSOR RANGE Alert Generated Automatic Faulty or incorrect thermistor caused by improper ohm reading
A102--- FST OPEN SENSOR Alert Generated Automatic Missing or open thermistor caused by wiring error or loose connection.
A103--- FST SHORTED SENSOR Alert Generated Automatic Faulty or shorted thermistor caused by wiring error or loose connection.
A104--- OAT SENSOR RANGE No free cooling, no low
ambient operation
Automatic Faulty or incorrect thermistor caused by improper ohm reading
A105--- OAT OPEN SENSOR No free cooling, no low
ambient operation
Automatic Missing or open thermistor caused by wiring error or loose connection.
A106--- OAT SHORTED SENSOR No free cooling, no low
ambient operation
Automatic Faulty or shorted thermistor caused by wiring error or loose connection.
A107--- RAT SENSOR RANGE No differential DB crossover Automatic Faulty or incorrect thermistor caused by improper ohm reading
A108--- RAT OPEN SENSOR No differential DB crossover Automatic Missing or open thermistor caused by wiring error or loose connection.
A109--- RAT SHORTED SENSOR No different ial DB crossover Automatic Faulty or shorted thermistor caused by wiring error or loose connection.
A110--- SPT SENSOR RANGE No heating or cooling Automatic Faulty or incorrect thermistor caused by improper ohm reading
A111--- SPT OPEN SENSOR No heating or cooling Automatic Missing or open thermistor caused by wiring error or loose connection.
A112--- SPT SHORTED SENSOR No heating or cooling Automatic Faulty or shorted thermistor caused by wiring error or loose connection.
A130--- CIR.A SSP SENSOR RANGE Shutdown Circuit A Automatic Faulty transducer, faulty 5--- V power supply, or loose connection
A131--- CIR.A SSP OPEN SENSOR Shutdown Circuit A Automatic Faulty transducer, faulty 5--- V power supply, or loose connection
A132--- CIR.A SSP SHORT SENSOR Shutdown Circuit A Automatic Faulty transducer, faulty 5--- V power supply, or loose connection
A133--- CIR.A SDP SENSOR RANGE Shutdown Circuit A Automatic Faulty transducer, faulty 5--- V power supply, or loose connection
A134--- CIR.A SDP OPEN SENSOR Shutdown Circuit A Automatic Faulty transducer, faulty 5--- V power supply, or loose connection
A135--- CIR.A SDP SHORT SENSOR Shutdown Circuit A Automatic Faulty transducer, faulty 5--- V power supply, or loose connection
A150--- OUTDOOR AIRFLOW IN CFM OPEN
SENSOR
No OACFM Operations Automatic Wiring problem, or configuration error
A151--- OUTDOOR AIRFLOW IN CFM
SHORTED SENSOR
No OACFM Operations Automatic Wiring problem, or configuration error
A160--- OARH OPEN SENSOR No Enthalpy crossover Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A161--- OARH SHORTED SENSOR No Enthalpy crossover Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A162--- RARH OPEN SENSOR No Differential Enthalpy
crossover
Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A163--- RARH SHORTED SENSOR No Differential Enthalpy
crossover
Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A164--- IAQ OPEN SENSOR No IAQ Operations Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A165--- IAQ SHORTED SENSOR No IAQ Operations Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A166--- OAQ OPEN SENSOR No OAQ Operations Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A167--- OAQ SHORTED SENSOR No OAQ Operations Automatic Bad sensor, bad wiring, or sensor configured incorrectly.
A168--- SPACE RELATIVE HUMIDITY OPEN
SENSOR
No dehumidifying Automatic Bad sensor, bad wiring, sensor configured incorrectly, loss of communication
to SIOB.
A169--- SPACE RELATIVE HUMIDITY
SHORTED SENSOR
No dehumidifying Automatic Bad sensor, bad wiring, sensor configured incorrectly, loss of communication
to SIOB.
A170--- ECON FEEDBACK RANGE No economizer diagnostics Automatic Wiring problem with actuator , or configuration error
A171--- ECON FEEDBACK OPEN No economizer diagnostics Automatic Wiring problem with actuator, or configuration error
A172--- ECON FEEDBACK SHORTED No economizer diagnostics Automatic Wiring problem with actuator , or configuration error
A190--- TSTA T HEAT/COOL CALLS Run unit in mode activated first Automatic Bad Thermostat or Thermostat Wiring
A191--- TSTAT IMPROPER COOL Run cooling per number of
active inputs
Automatic Bad Thermostat or Thermostat Wiring
A192--- TSTAT IMPROPER HEAT Run heating per number of
active inputs
Automatic Bad Thermostat or Thermostat Wiring
F200--- FIRE SHUTDOWN Unit Shutdown Automatic Smoke detected by smoke detector
F201---CONDENSATE OVERFLOW Cooling Shutdown Automatic Dain pan plugged, sensor error, or configuration error
A203--- DIRTY FILTER Alert Generated Automatic DirtyFilterorfiltertimerexpired
F204--- REMOTE SHUTDOWN Unit Shutdown Automatic Remote activation of the shutdown switch
F205--- IDF MANUAL LIMIT TRIP Unit Shutdown Automatic LimitSwitchonIndoorFantripsduetohightemperatureatthemotor
F206--- PHASE MONITOR TRIP Unit Shutdown Automatic Power supply phase missing or out of phase

Table of Contents

Related product manuals