Need help?Do you have a question about the Carrier 50QQ and is the answer not in the manual?
Inspect unit, unpack, and verify system requirements before installation.
Procedures for mounting the heat pump on the ground or roof.
Connect supply and return air ductwork to the unit.
Connect drain line for condensate and ensure proper disposal.
Install branch circuit disconnect, route power leads, and connect wiring.
Set anticipator settings for room thermostat according to installation instructions.
Provides adjustable outdoor control of accessory electric heaters.
Locate and fasten outdoor thermostats in the controls section.
Mount the supplemental heat relay in the low-voltage section.
Step-by-step guide to starting the unit after installation.
Procedure to check the start thermistor for compressor operation issues.
Explanation of high-pressure relief valve, overload, and defrost control.
Details on defrost timer, thermostat, and defrost cycle.
Superheat charging method using labels and charts.
Procedures for cleaning or replacing metering device components.
Steps for removing the compressor, including safety precautions.
Install an accessory liquid line filter drier assembly.
Information on compressor oil charge and type.
Lubrication intervals and procedures for fan motor bearings.
Inspect and clean the indoor coil.
Clean the condensate drain trap and flush the pan.
Adjust, clean, and reassemble the indoor fan assembly.
Adjust, remove, and reconnect outdoor air fan and motor.
Replace disposable filters and clean permanent filters regularly.
Inspect and clean the outdoor coil regularly to prevent issues.
Detailed steps of the cooling cycle operation.
Detailed steps of the heating cycle operation.
How the defrost control operates to remove frost.
Chart to diagnose and resolve heating cycle issues.
Chart to diagnose and resolve cooling cycle issues.
To Next Page
General
