To Next Page
R
Richard RhodesAug 1, 2025
What does E1 mean on Carrier Thermostat?
- TTeresa BallAug 1, 2025
If the Display Module and the Equipment Control Module cannot communicate via two--wire connection, an E1 will be displayed.
What does E1 mean on Carrier Thermostat?
If the Display Module and the Equipment Control Module cannot communicate via two--wire connection, an E1 will be displayed.
How to troubleshoot Carrier A07049 Thermostat display module not powering up?
If your Carrier Thermostat's display module doesn't power up, begin by checking the Rc/Rh and C terminals to ensure they are receiving 24VAC. If 24VAC is present, then check the voltage between Vg and V+. If voltage is present, verify the wiring polarity is correct, as the display won't power up if the polarity is reversed.
What to do if Carrier A07049 Thermostat Control’s internal memory fails?
If the Thermidistat Control's internal memory fails, you should replace the Thermidistat Control.
How to fix Carrier Thermostat display module if it doesn’t power up?
If the display module doesn’t power up after power is applied, check the Rc/Rh and C terminals for 24VAC. If 24VAC is present, check the voltage between Vg and V+. This voltage will be approximately 12--20VDC. If voltage is present, check the polarity to make sure it is wired correctly. The display will not power up if polarity is reversed.
What to do if Carrier A07049 Thermostat Control cannot properly read humidity?
If the Thermidistat Control cannot properly read humidity, replace the Thermidistat Control.
Overview of available configuration options for the thermostat.
Procedure to enter the thermostat's configuration mode.
Detailed selection and explanation of configuration parameters.
How to test heating and cooling equipment using installer mode.
Steps to troubleshoot display module power issues.
Interpretation and resolution of specific error codes displayed.
Wiring diagram for connecting display to equipment control module.
General| Product Type | Thermostat |
|---|---|
| Display Type | Digital |
| Hold Feature | Yes |
| Filter Change Alert | Yes |
| Battery Backup | Yes |
| Compatibility | Single Stage Heat/Cool |
| Power Source | Battery |
| Temperature Range | 45°F to 90°F |
| Stages | 1 |
