72
• Touch START on Infinity System Control or service tool to open the
valve.
• Begin evacuation or refrigerant recovery as required for the procedure
after control indicates the EXV is open. Power may be removed from
heat pump after the control indicates “READY TO EVACUATE.”
6.6.4. EXV Position
This screen allows the installer to set the EXV position and monitor the
suction pressure.
NOTE: Screen data will vary based on unit installed.
A14233
6.7. Dealer Logo for Series B
NOTE: More detailed information can be found on HVACPartners.com
under: Products and Dashboards > Product Catalog > Residential
Controls < Systems Controls > SYSTXCCITC01-C > Documents >
Marketing > Miscellaneous > Infinity SystemControl Dealer Logo
Application - Instructions.
Touch DEALER LOGO to upload the dealer logo and contact
information from a micro SD card connected to the Infinity System
Control. The “Dealer Logo Application” PC/MAC Desktop application
download available at www.MyInfinityTouch.Carrier.com is required to
To Next Page
Loading...
