LEGEND
*The inverter control assembly (item 16) and rectifier control assembly (item 18) are physically similar but are loaded with different
software.
These boards are NOT interchangeable.
Fig. 20 — Power Module Components
1 — Wire Harness Assembly, Gate Driver 14 — Wire Harness Assembly, DC Bus Bleeder Resistors
2 — Current Feedback Device, 1000 A 15 — Wire Harness Assembly, Line Sync
3 — Wire Harness Assembly, Power Supply, Logic 16 — Inverter Control Assembly*
4 — 80 W Power Supply Assembly 17 — Standard I/O Option, 24 V Assembly
5 — Terminal Block, 2-Position 18 — Rectifier Control Assembly*
6 — Cable Assembly, 40-Pin 19 — AC Line I/O Assembly
7 — Cable Assembly, 30-Pin 20 — Connector, Terminal Block, 32-Pin
8 — Wire Harness Assembly, Power Supply, Upper Gate 21 — NTC Assembly
9 — Inverter Power Interface Assembly 22 — Internal Fan
10 — Wire Harness Assembly, Power Supply, Lower Gate 23 — DPI Communications Interface Assembly
11 — Insulation Sheet 24 — RS-485 Communications Assembly (VFD Gateway)
12 — Rectifier Power Interface Assembly 25 — Wire Harness Assembly, Control Sync
13 — Wire Harness Assembly, Current Feedback Device 26 — Cable Assembly, 20-pin
Door Open
Door Closed
a23-1627