Carrier CDF2-16Q7 - Control Pads on the Dehumidifier; Control Pads

CONTROL PADS ON THE DEHUMIDIFIER
CONTROL PADS ON THE DEHUMIDIFIER
12
GB
Control pads
When you push the button to change operation modes, the unit
will make a beep sound to indicate that it is changing modes.
1
Power Pad
Press to turn the dehumidier on and off.
NOTE: When the compressor startups or stops running, the
unit may make a loud voice, it is normal.
2
Mode/Wireless Pad(wireless is optional)
Press to select the desired operation mode from
Dehumidifying, Dryer, Continuous dehumidifying and Smart
dehumidifying.
NOTE: Dryer and Smart dehumidifying modes are optional.
Press the MODE pad for 3 seconds to initiate the Wireless
connection mode. The LED DISPLAY shows AP (at this time
the unit shuts off all other functions)to indicate you can set
Wireless connection. If connection (router) is successful
within 8 minutes, the unit will exit Wireless connection
mode automatically and the unit reverts previous state.
If connection is failure within 8 minutes, the unit exits the
Wireless connection mode automatically.
3
+
/
-
: Up/Down Pads
• Humidity Set Control Pads
The humidity level can be set within a range of 35%RH
(Relative Humidity) to 85%RH (Relative Humidity) in 5%
increments.
For drier air, press the
-
pad and set to a lower percent value
(%).
For damper air, press the
+
pad and set a higher percent
value (%).
• TIMER Set Control Pads
Use the Up/Down pads to set the Auto start and Auto stop
time from 0.0 to 24.
NOTE: Press
+
pad for 3 seconds to show the room
temperature and quit to show room temperature after 10
seconds.
4
Timer Pad
Press to initiate the Auto start and Auto stop feature, in
conjuction with the and pads.
5
Fan/Self clean Pad
Control the fan speed. Press to select fan speed in three
steps-low, med and high. The fan speed indicator light
illuminates under different fan speed settings. But when
select high fan speed, both the low and med fan speed lights
illuminate.
NOTE: The fan pad is disabled in Dryer mode and when the
Self clean, Air purier and Anti-mould functions are enabled.
Pressing the fan pad for more than 3 seconds enables the
Self clean funtion and the LED DISPLAY shows ‘SC’ for 5
seconds. Press this pad for 3 seconds again to cancle the
Self clean function, the LED DISPLAY ashes ‘SC’ for 5
seconds.
6
Pure/Anti-mould Pad
Press this pad to select the Air purier function which uses
the included HEPA (High Efciency Particulate Air) lter to
reduce the dust, bacteria and allergen content in the room.
Press the pad for 3 seconds to enable the Anti-mould
function. Press this pad for 3 seconds again to cancle the
Anti-mould function and the unit revents previous state.
7
Display Window
Shows the set % humidity level from 35% to 85% or auto
start/stop time (0~24) while setting, then shows the actual
(
±
5% accuracy) room % humidity level in a range of
30%RH (Relative Humidity) to 90%RH (Relative Humidity).
Shows the room temperature by pressing the
+
pad for 3
seconds.
Error Codes and Protection Codes:
NOTE: The control panel of the unit you purchased may be slightly different according to the models.
Fig.1
CONTROL PADS ON THE DEHUMIDIFIER