Carrier CDF2-16Q7 - Page 16

CONTROL PADS ON THE DEHUMIDIFIER
IDENTIFICATION OF PARTS
14
GB
Setting the Timer
● When the unit is on, rst press the Timer button, the Timer
Off indicator light illuminates. It indicates the Auto Stop
program is initiated. Press it again the Time On indecator
light illuminates.It indicates the Auto Start is initiated.
● When the unit is off, rst press the Timer button, the TIMER
ON indicator light illuminates. It indicates the Auto Start
program is initiated. Press it again the Time Off indecator
light illuminates.It indicates the Auto Stop is initiated.
● Press or hold the UP or DOWN pad to change the Auto time
by 0.5 hour incre- ments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will count down the
time remaining until start.
● The selected time will register in 5 seconds and the system
will automatically revert back to display the previous humidity
setting.
● When the Auto start & Auto stop times are set, within the
same program sequence, TIMER ON OFF indicator lights
illuminate identifying both ON and OFF times are now
programmed.
● Turning the unit ON or OFF at any time or adjusting the timer
setting to 0.0 will cancel the Auto Start/Stop function.
● When LED display window displays the code of P2, the Auto
Start/Stop function will also be cancelled.
Dryer mode(optional)
The unit can make the MAX dehumidication function when it is
under the Dryer mode. The fan speed is xed at high fan speed.
30~50cm
30~50cm
Wet clothes
Airow
Fig.A
Allow 30~50cm of distance on the
top and right side of the unit to
the wet clothes.
NOTE:
● The Dryer mode must be operated in a close room, do not
open the door and window.
● To make the best effective dehumidication, please rst
dehydrate the wet clothes.
● Make sure to direct airow at the wet clothes (See Fig. A).
● For thick and heavy wet clothes may not get the best
effective dehumidication.
!
CAUTION
● Do not cover the air outlet of the unit with clothes. It may
cause excessive heat, re or failure of unit.
● Do not place the wet clothes on the top of the unit and do
not make the water drop into the unit. It may cause electric
shock, creepage or failure of unit.