Carrier DC Series User Manual

Welcome and overview of Carrier's commitment to quality and unit features.

Read instructions before starting and remove chassis from casing for installation.

Comply with codes, ensure proper grounding, and match wall outlet to unit plug.

Requirements for individual branch circuits and understanding nameplate specifications.

Diagram of the control panel and instructions for OFF, FAN, and COOL modes.

How to set the thermostat dial and direct airflow for comfort.

Operating the unit with POWER, MODE (COOL, FAN, HEAT), and TEMP buttons.

Using DRY, FAN speed selection, and SLEEP functions for enhanced comfort.

Setting unit timers and procedures for replacing remote control batteries.

How to activate emergency mode using an internal button on the electronic panel.

Operation of exhaust system to expel stale air and vent system to draw fresh air.

Optimize settings and maintenance for energy savings.

Maximize cooling by closing vents and pre-cooling the room.

Remove unit components and check window mounting kit contents.

Measure window opening, adjust for storm windows, and install bottom track.

Install wing panels and position/secure the mounting kit to the window frame and sash.

Install foam seal, fasten panels, and slide the unit chassis into the casing.

Cut wall opening, ensure clearances, and frame the opening for casing installation.

Install casing with outward tip and secure it to the wall structure.

Insert chassis into casing and finish the exterior wall opening.

Troubleshooting common causes for the unit not starting or cooling.

Resolving issues related to noises, water dripping, and ice/frost formation.

Details of the one-year and four-year limited warranties and their exclusions.

Steps to check yourself before contacting service for a non-working unit.

How to contact dealer, service center, distributor, or Carrier for assistance.