Carrier i-Vu CIV-OR - Network Configuration and Addressing; Addressing and IP Schemes

Installing the i-Vu® Open Router
i-Vu® Open Router CARRIER CORPORATION ©2020
Installation and Start-up Guide All rights reserved
6
Addressing the i-Vu® Open Router
The i-Vu® Open Router needs two addresses, one for the Open network and one for the IP Network.
The i-Vu® Open
Router needs...
That is unique
on the...
Notes
A router address
Open network
You set the i-Vu® Open Router address on the rotary switches.
(1-99)
NOTE The i-Vu® Open Router address is also used to auto-
generate the BACnet device instance/name for the router and
the MS/TP network number for the connected Open network.
See Configuring BACnet device instance and network number
for more information.
An IP address
IP Network
Use the IP Address DIP switch to choose one of the following:
• Use DHCP to obtain an IP address
• Assign a custom IP address (default)
The default IP settings are:
• 192.168.168x, where x = router address
• subnet mask = 255.255.255.0
• default gateway = 192.168.168.254
To set the i-Vu® Open Router address on the Open network
CAUTION The i-Vu® Open Router address must be unique on the IP and Open network.
1 If wired for power, turn off the power.
NOTE The i-Vu® Open Router only reads the rotary switch positions during power up or upon reset.
2 Use the rotary switches to set the address. Set the Tens (10's) switch to the tens digit of the address, and set
the Ones (1's) switch to the ones digit. Valid addresses are 1 - 99.
EXAMPLE If the controller’s address is 25, point the arrow on the Tens (10's) switch to 2 and the arrow on
the Ones (1's) switch to 5.
10's 1's
1
3
4
5
2
7
8
9
6
0
1
3
4
5
2
7
8
9
6
0
3 Turn on the i-Vu® Open Router's power.
CAUTION The factory default setting is 00 and must be changed to successfully install your i-Vu® Open
Router.