Installing the i-Vu® Open Router
i-Vu® Open Router CARRIER CORPORATION ©2020
Installation and Start-up Guide All rights reserved
4
1 Mount the i-Vu® Open Router (page 4).
2 Wire for power (page 5).
3 Set the i-Vu® Open Router's address and IP address (page 6).
4 Wire for communications (page 10).
5 Communicate through the Local Access port (page 12).
6 Configure BACnet Device Instance and network number (page 15).
Mounting the i-Vu® Open Router
WARNING
When you handle the i-Vu® Open Router:
• Do not contaminate the printed circuit board with fingerprints, moisture, or any foreign material.
• Do not touch components or leads.
• Handle the board by its edges.
• Isolate from high voltage or electrostatic discharge.
• Ensure that you are properly grounded.
Screw the i-Vu® Open Router into an enclosed panel using the mounting slots on the cover plate. Leave about 2
in. (5 cm) on each side of the controller for wiring.
To Next Page
Loading...