13
328964-101 REV. A
1. Use Copper Wire (75ºC Min) Only
Between Disconnect Switch And Unit.
2. To Be Wired In Accordance With NEC
And Local Codes.
3. If Any Of The Original Wire, As
Supplied, Must Be Replaced, Use The
Same Or Equivalent Type Wire.
4. Replace Low Voltage Fuse With No
Greater Than 5 Amp Fuse.
5. (3) Speed Motor Shown Optional (2)
Speed Motor Uses HI (BLK) And LOW
(BLUE or RED).
6. Connect R To R, G To G, Etc. See
Outdoor Instruction For Details.
NOTES
A07027
Fig. 15 -- 328964--101
To Next Page
Loading...
