What to do if Carrier TP-NRH display module doesn’t power up?
If the Carrier Thermostat display module doesn't power up, check the Rc/Rh and C terminals for 24VAC. Also, check the voltage between Vg and V+. Ensure the polarity is correct during wiring, as the display will not power up if the polarity is reversed.
What to do if Carrier TP-NRH Control cannot properly read humidity?
If the Carrier Thermostat Control cannot properly read humidity, replace the Thermidistat Control.
What to do if Carrier Thermostat Control’s internal memory fails?
If the Carrier Thermostat Control’s internal memory fails, replace the Thermidistat Control.
Discusses thermostat models and connections for humidify equipment.
Details dehumidify connections and outdoor temperature sensors.
Information on remote sensors and two-piece installation.
Guidelines for mounting the Thermidistat Control for accurate temperature readings.
Detailed steps for installing the thermostat in a two-piece configuration.
Detailed steps for installing the thermostat in a single-piece configuration.
Overview of all available configuration options for tailoring the thermostat.
Procedures for entering and using the configuration mode on the thermostat.
Explanations of specific configuration settings and their parameters.
How to use the built-in installer test capability to check equipment operation.
Procedures for testing the fan and setting the final system operation mode.
How to select and use humidification features for home comfort.
How to select and use dehumidification features for home comfort.
Explains compressor timeguard, cycle timer, and staging timers.
Details how the system handles defrost cycles in hybrid heat systems.
Explains the meaning of icons displayed on the thermostat during operation.
Lists and explains error codes that may appear on the display.
Section for recording hardware setup details.
Section for recording system mode and setpoint configurations.
Section for recording special comfort settings.
Section for recording programmable schedule details.
General| Power Source | Battery-powered (2 AA batteries) |
|---|---|
| Backlight | Yes |
| Mounting | Wall-mounted |
| Programmability | 7-day programmable |
| Display | LCD |
| Compatibility | Most HVAC systems |
| Accuracy | +/- 1°F (+/- 0.5°C) |
To Next Page
