What to do if my Carson Air Zermatt SA 315B Lama model does not move?
If your Carson Toy model isn't moving, there are a few things you can check: * Make sure both the transmitter and receiver are switched on. If not, switch them on. * Verify the battery voltage of both the transmitter and receiver. Use fully charged batteries. * Ensure the trim slider of the pitch function is in the neutral position or slightly below.
Why does my Carson Air Zermatt SA 315B Lama model vibrate severely?
If your Carson Toy model is vibrating severely, check the following: 1. Make sure the principal rotors run true. If necessary, change the rotor blades. 2. Confirm that the model is correctly balanced. Changing the rotor blades might help.
What to do if my Carson Air Zermatt SA 315B Lama Toy model does not take off?
If your Carson Toy model is not taking off, consider the following: * Check if the rotor blades are twisted and exchange them if needed. * Ensure the motor isn't too hot by allowing it to cool down. * Make sure the batteries aren't empty. Charge or replace them as necessary.
Why won't the tail of my Carson Toy model stabilize?
If the tail of your Carson Toy model won't stabilize, here are some things to check: 1. See if any rotor blades are defective and replace them if needed. 2. Ensure the lower and upper rotor revolutions rotate easily on the rotor shaft. 3. Correct the trim on the transmitter to adjust the velocity of rotation of the upper and lower rotor revolution.
What to do if motor of Carson Air Zermatt SA 315B Lama Toy does not turn?
If the motor of your Carson Toy does not turn, it could be due to the following reasons: * The motor might be defective, in which case you should exchange it. * The motor might be too hot; allow it to cool down.
What to do if my Carson Air Zermatt SA 315B Lama rotors do not allow shut down?
If the rotors of your Carson Toy do not allow shut down, correct the trim on the pitch controller.
What to do if my Carson Toy model reacts incorrectly?
If your Carson Toy model reacts incorrectly to control commands or flies choppily, employ completely charged batteries.
What to do if my Carson Air Zermatt SA 315B Lama Toy moves but doesn't hover?
If your Carson Toy model moves forward/backward and sidewise but doesn't hover, check for any draughts, such as an opened window or an air conditioner. Close the window/door, switch off the air conditioner, or select a more suitable room, as hover flight is not possible when there is a draught.
General| Power Source | Electric |
|---|---|
| Channels | 3 |
| Frequency | 2.4 GHz |
| Model | Zermatt SA 315B Lama |
| Material | Plastic |
| Control | Remote |
| Battery | LiPo |
| Brand | Carson |
To Next Page
