6
GB
Specter 202001 · 202002 · 204003 · 204006
Tools needed for the assembly
Scissors 13305Needle nose pliers 74034
Side cutter 74035
Modelling knife 74053
Hexagonal wrench 13118Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm 74023
Instant adhesive 53339
Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the center
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Receiver antenna
Batteries for receiver
Engine
throttle
servo
Steering servo
Switch
Transmitter
Your 2 channel radio system
Tweezers 74003
To Next Page
Loading...
Need help?
General
