EasyManua.ls Logo

Carver 4350 - User Manual

Carver 4350
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CARVER
®
OPERATION, INSTALLATION AND MAINTENANCE MANUAL
4350 MANUAL PELLET PRESS
IMPORTANT:
PLEASE READ CAREFULLY BEFORE INSTALLING OR OPERATING THIS EQUIPMENT
CARVER, INC.
1569 Morris Street, P.O. Box 544
Wabash, IN 46992-0544
PH: 260-563-7577 FAX: 260-563-7625

Table of Contents

Questions and Answers

  • A
    Andre BlackburnAug 11, 2025
    Why is there a rapid drop in pressure in my Carver 4350 Power Tool?
    • G
      gibsonamandaAug 11, 2025
      If your Carver Power Tool experiences a rapid drop in pressure, several factors could be responsible. First, check for low oil levels caused by leakage and tighten any loose hydraulic connections before refilling the oil. Ensure the release valve is fully closed. If the issue persists, the internal packing might be worn or dislodged, requiring replacement of the packing or seals. A dirty valve seat can also cause this; remove the release valve and clean the valve seat, considering flushing the hydraulic unit. Lastly, air entrapment could be the culprit, so purge the air from the system.
  • M
    mary28Aug 21, 2025
    What to do if my Carver 4350 has no pressure when pumping?
    • R
      Rachel Jones MDAug 21, 2025
      If your Carver Power Tool isn't building pressure when pumping, start by ensuring the release valve is completely closed. If that doesn't solve the problem, the pump packing may be worn, necessitating replacement or rebuilding of the hydraulic unit pump. Also, check if the release valve ball is missing and replace it if needed. Finally, the release valve might be contaminated, in which case you should remove and clean it.
  • M
    Mary ThomasAug 30, 2025
    What to do if my Carver Power Tool has a slow drop in pressure?
    • R
      Rebecca BurnsAug 30, 2025
      If your Carver Power Tool experiences a slow drop in pressure, ensure the release valve is fully closed. If the problem continues, the release valve seat might be worn, requiring you to contact the factory for a replacement. Another potential cause is a worn ram seal, which would need to be replaced.

Carver 4350 Specifications

General IconGeneral
BrandCarver
Model4350
CategoryPower Tool
LanguageEnglish