- 3 -
STEP 3
Plug in speaker to output 1 or 2, they
are both the same, both jacks are in
parallel.
NOTE: For speaker setup click on
“Troubleshooting” and “Speakers”.
IMPORTANT: Do NOT turn on the
amplifier without a speaker plugged
in!"
STEP 4
Make sure the OHM setting is
correct. Improper setting will result
in damage to the amp!
NOTE: On the back is where you
will find the OHM setting, make sure
the speaker matches the OHM
setting.
STEP 5
A) Lower the volume down on both
channels.
B) Unplug your guitar cord from the
input of the amp.
NOTE: If you have signal going
through the amp, it will not be the
true reading, when you set the bias.
To Next Page
Loading...
