13
12
Press the MODE key to have
number increase. To move
flash to next digit, press
the TARE key.
Press ZERO key to set up HIGH
limit. The display shows
"0.00" and you can change
these numbers by pressing
MODE key. If you want to move
to next digit you can go by
pressing TARE key.
If you set up HIGH limit you
can go out by pressing ZERO
key, and you can see "ENd"
message shortly and "WL
on" message on the display.
If you set up HIGH limit and LOW limit incorrectly, "Err" will be shown on the display.
Then you may need to set it up again. For example, LOW LIMIT=39.90 kg and HIGH
LIMIT=49.90 kg this is incorrect setting because HIGH limit is lower than the LOW limit.
When HIGH and LOW limit are set as the same or above maximum capacity it still shows
"Err" message.
If you want to go back to the
simple weighing mode just
press MODE key twice.
Suppose that the HIGH limit and
LOW limit are set up as 49.90kg
and 39.90kg respectively. If the
weight loaded is 2kg between
HIGH and LOW limit the display
shows "OK" and the scale
continues to beep slowly.
If the weight loaded is above
49.90kg, HIGH limit, the scale
continues to beep rapidly.
6. Counting Function
Counting without Tare
Initial display as above. Press MODE key three times
to go to sample unit
selection mode.
Press ZERO key to select the
number of sample unit. You
can select 10, 20, 30, 40,
50,60, 70, 80, 90, 100, 200,
300,400, or 500 as a sample
unit.
If you select "P_10" as a
sample unit, then please
put 10 sample units on the
scale. Then press TARE key
to set sample units.
Put all of commodities you
wish to count, and then
check the number of pieces
on display.
Remove all of commodities
from the scale.
To Next Page
Loading...
Need help?
General
