EasyManua.ls Logo

Casablanca Bel Air Halo User Manual

Casablanca Bel Air Halo
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
CIRCUIT BREAKER
(TRIP BREAKER FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
FUSE BOX
(REMOVE FUSE FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
18ʺ
84ʺ
70ʺ
The blades in each pack are matched for
equal weight to assure smooth fan operation.
If more than one fan is being installed, be
careful not to mix blades from different
cartons.
Inspect the contents of your carton for
possible shipping or handling damage and
report any such damage directly to your
authorized Casablanca dealer.
It is always a good idea to have an assistant
to help with the installation.
When cleaning, painting, or working near
your fan, be very careful of the fan and
blades. Always turn the power OFF to the
ceiling fan before servicing it, working on
it, or replacing light bulbs.
Never insert anything into the path of the
fan blades while the fan is in operation.
Never install a fan over a pool or spa.
Never operate a fan that has been damaged in
any way. Contact Casablanca Fan Company by
calling toll free 1-888-227-2178, or contact
your local authorized Casablanca dealer for
assistance in obtaining service.
CONTENTS
READ AND SAVE THESE INSTRUCTIONS
SAFE USE
Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product
and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this
owner’s manual completely and carefully. Retain this manual for future reference.
SAFETY FIRST
BEFORE YOU START
P/N 3843010 REV. G BM0404
CAUTION: To avoid possible electrical shock, make certain that electricity is turned off at
the circuit breaker or fuse box before attempting any installation procedure.
CAUTION: RISK OF ELECTRICAL SHOCK! All wiring must be performed in accordance with national and local electrical
codes. If you are unfamiliar with the wiring codes, you should use a qualified electrician. To avoid overheating and
possible damage to other equipment, do not install control to a receptacle, fluorescent light fixture, motor operated
appliance, or transformer-supplied appliance..
This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan
installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling
installations.
This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts. Maximum light
current is 2.8 amps or 340 watts of lighting.
Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy hatch, make
sure all wires are within the canopy and that no wires are being pinched.
For best performance and for your warranty to be valid, use only genuine Casablanca blades, light fixtures, and accessories.
INTRODUCTION 1
MOUNTING RECOMMENDATIONS 2
FAN INSTALLATION 3
CONTROL FEATURES:
INTELI•TOUCH OPERATION 9
INTELI•TOUCH TROUBLESHOOTING 12
INTELI•TOUCH 2 OPERATION 13
INTELI•TOUCH 2 TROUBLESHOOTING 15

Other manuals for Casablanca Bel Air Halo

Question and Answer IconNeed help?

Do you have a question about the Casablanca Bel Air Halo and is the answer not in the manual?

Casablanca Bel Air Halo Specifications

General IconGeneral
TypeCeiling Fan
Light KitIncluded
Control TypeRemote Control
FinishBrushed Nickel
Downrod Length4.5 inches
Light Kit IncludedYes
Reversible MotorYes

Summary

Installation Instructions

Perma-Lock Hardware

Details on the specific hardware used for securing the downrod to the fan motor.

Fan Preparation

Steps to prepare the fan motor and downrod assembly before mounting.

Getting Started with Outlet Boxes

Guidance on installing or verifying ceiling outlet boxes for fan support.

Ceiling Hardware Installation

Crossbar Mounting Bracket Installation

Instructions for attaching the crossbar mounting bracket to the ceiling outlet box.

Fan Canopy and Lag Screw Installation

Lag Screw Installation

Procedure for securing the mounting bracket using lag screws into the ceiling structure.

Fan Hanging and Wiring

Hanging the Fan

Procedure for safely hanging the fan body onto the canopy mounting system.

Canopy Electrical Connections

Guide for connecting the fan's wires to the ceiling electrical supply.

Inteli-Touch Wall Control Installation

Single W-32 Wall Control

Wiring and installation guide for a single Inteli-Touch W-32 wall control.

Dual W-32 Wall Control

Instructions for installing two Inteli-Touch W-32 controls for a three-way circuit.

Inteli-Touch Operation and Controls

Troubleshooting and Maintenance

Common Problems and Remedies

Solutions for issues like fan wobbling, noise, and speed control problems.

Inteli-Touch2 Wall Control Installation

Related product manuals