FILE NAME ( W500WallControl.pmb) ras 07-09-04
Casablanca Fan Co. - Factory Service Department - Technical Library
1
W-500™ Control includes all of the standard features, in a new design that is
compatible with a number of Casablanca fan Models . The W-500™ hand-held
remote provides three forward or reverse fan speeds, full spectrum light dimming
and has an optional wall bracket. The W-500™ may be used alone to control
several fans or with extra controls to operate a single fan from different locations.
W-500
(Transmitter)
SCREW
6-32 X 1”(2)
WOOD SCREW
1” (2)
DRYWALL
ANCHOR
6-32 (2)
12V BATTERY
W-500™ INSTALLATION
W-500™ CONTROL BRACKET INSTALLATION
Standard Light Switch
Step A. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step C. Install and tighten screws by hand only.
CAUTION! Do not use with wall dimmer or rocker switch.
W-500
CONTROL
(TRANSMITTER)
W-500
CONTROL
HOLDER
SCREW
6-32 X
3
/8” (2)
Wall Controls - CONTINUED
Rocker
Switch
Standard Switch
NOTE: - If a ROCKER SWITCH is being use to con-
trol the fan location, it must be changed to a STAN-
DARD SWITCH as shown.
W-500
™
To Next Page
Need help?
General
