Case 2010 - Page 24

SECTION 00 - GENERAL INFORMATION - CHAPTER 2
00-6
Head Size
6.1 m 7.6 m 9.2 m
(20′)(25′)(30′)
Knife speed 560 CPM 560 CPM 560 CPM.................................
(left side) (left side) (left side)
(1120 spm) (1120 spm) (1120 spm)
575 CPM 575 CPM 575 CPM
(right side) (right side) (right side)
(1150 spm) (1150 spm) (1150 spm)
Cutter bar
Flexible cutter bar style integral to header frame.......................
Flexible cutter bar vertical 114 mm 114 mm 114 mm.....................
float range (4-1/2″) (4-1/2″) (4-1/2″)
Knife sections (bolted) easy bolt 1-1/2″ - overserrated *.......................
Knife guards forged steel - heat treated................................
Knifestroke 76mm 76mm 76mm.................................
(3″)(3″)(3″)
Cross Auger
Standard speed 158 RPM 158 RPM 158 RPM.............................
Slow speed 139 RPM 139 RPM 139 RPM.................................
Outside diameter 660 mm 660 mm 660 mm............................
(26″)(26″)(26″)
Flighting pitch 660 mm 660 mm 660 mm...............................
(26″)(26″)(26″)
Flighting width 127 mm 127 mm 127 mm..............................
(5″)(5″)(5″)
Number of auger fingers (Full Length) 28 30 32..........
Finger diameter 16 mm 16 mm 16 mm.............................
(0.625″) (0.625″) (0.625″)
Reach beyond center tube 173 mm 173 mm 173 mm....................
(6-13/16″) (6-13/16″) (6-13/16″)
Auger adjustments 4 4 4...........................
directions directions directions
Auger mounting free to free to free to.............................
float float float
vertically vertically vertically
*3″ knife and guards optional on 20′
,25′, and 30′.