SECTION 55 - ELECTRICAL - CHAPTER 1
55-3
The header type sensor, 1, is tie wrapped to the wire
harness, 2, at the rear of the head. The wire harness
connects to the combine electrical system through
connector, 3.
The header type sensor informs the combine what
type of head is attached. The wires on the 2010 and
2020 heads should be connected:
Wire No. Pin No.
HD1223 A
HD1116 E
HD750 F
All other sockets in the header type sensor should be
plugged.
10032061
1
2
3
4
To Next Page
Loading...
