Case 48083741 - Page 22

INTRODUCTION
Reassemblinghydraulicequipment
•
Cleanpartsinawellventilatedroom.
•
Removeresidualoilwithcompressedair,andapplyfreshhydraulicoilorgearoiltosurfacesbeforereassembly.
•
Replaceremovedo-rings,back-upringsandoilsealswithnewones.Applygearoilonthembeforereassembling.
•
Thoroughlycleananddrysurfacesonwhichliquidsealantmustbereapplied.
•
Beforeassembling,removerustpreventivesonnewparts.
•
Usespecialtoolstotbearings,bushingandoilseal.
•
Assemblepartsmatchingtothemarks.
•
Aftercompletion,checkthatthereisnoomissionofparts.
48083741_EN31/07/2018
17