2000-8
30. Connect the wire to the fuel shutoff solenoid.
NOTE: If the machine is equipped with air
conditioning, do Steps 31 through 36. If the
machine is not equipped with air conditioning
go to Step 37.
31. Remove the wire that was used to tie the
compressor out of the way and install the
compressor on the mounting bracket. Align the
compressor with the mounting bracket and install
the bolt, lock washer, and flat washer.
32. Install the nut on the bolt and tighten the nut.
33. Install the belt on the pulley for the compressor.
Install the cap screw, lock washer, and flat
washer that fasten the adjusting strap for the
compressor. Do not tighten the cap screw all the
way at this time.
34. Use a prybar to move the compressor away from
the engine. Tighten the cap screw.
35. Check the tension on the belt with a tension
gauge. See Section 1001 for belt tension.
36. Attach the connectors for the compressor and
install a new tie strap to fasten the wire harness
to the fuel line.
37. Connect the wire for the temperature sender.
38. Install the cap screw and lock washer that fasten
the clamp for the wire harness to the left side of
the flywheel housing. Tighten the cap screw.
Install the wires on the stud. Install the copper
flat washer and the copper nut on the stud and
tighten the copper nut.
39. Connect the cables to the battery terminal of the
starter solenoid.
40. Connect the wire to the switch terminal of the
starter solenoid.
41. Install the cap screw for the clamp that fastens
the heater hose to the engine.
42. Install the small wire on the alternator. Install the
lock washer and nut. Tighten the nut.
43. Install the wire to the battery terminal on the
alternator. Install the lock washer and nut.
Tighten the nut.
Bur 7-12150
44. Install the external tooth washer, the ground
cable, the lock washer, and the cap screw.
Tighten the cap screw.
45. Remove the plug from the heater hose and
connect the heater hose.
46. Install the cap screw that fastens the clamp for
the wire harness. Tighten the cap screw.
47. Install the air cleaner in the bracket.
48. Install the bolts and nuts that fasten the straps.
Tighten the bolts.
49. Connect the hose and tighten the hose clamp.
50. Connect the wires to the switch for the air
cleaner indicator.
51. Remove the cover or the tape from the opening
in the exhaust elbow and install the muffler.
52. Install the bolts, flat washers, lock washers, and
nuts that fasten the bracket for the muffler to the
bracket on the engine. Tighten the nuts.
53. Tighten the nut on the bolt for the muffler clamp.
54. Install the radiator shroud over the frame and
carefully lower the radiator shroud over the
hydraulic oil cooler.
55. Lower the radiator shroud into alignment with the
frame. Disconnect the lifting equipment from the
radiator shroud.
56. Install the hardware that fastens the front of each
side of the radiator shroud to the frame. Tighten
the hardware.
57. Connect the top radiator hose to the radiator.
58. Connect the bottom radiator hose to the water
pump.
59. Install the guard.
60. Install the cap screws, lock washers, and flat
washers that fasten the clamps for the hose and
the guard to the fan shroud. Tighten the cap
screws.
Issued 1-99 Printed in U.S.A.
To Next Page
Loading...
