Case 680 CK User Manual

,----------------------1
SERVICE MANUAL
Loaders
680 CK
Series C
9-72595
--------------------~
1. Trim along dashed line. b
2. Slide into pocket on Binder Spine.
TYPE 1-4
,----------------------1
SERVICE MANUAL
Loaders
680 CK
Series C
9-72595
--------------------~
1. Trim along dashed line. b
2. Slide into pocket on Binder Spine.
TYPE 1-4
,----------------------1
SERVICE MANUAL
Loaders
680 CK
Series C
9-72595
--------------------......,:0
1. Trim along dashed line. b
2. Slide into pocket on Binder Spine.
TYPE 1-4
,----------------------1
SERVICE MANUAL
Loaders
680 CK
Series C
9-72595
--------------------......,:0
1. Trim along dashed line. b
2. Slide into pocket on Binder Spine.
TYPE 1-4

Case 680 CK Specifications

General

Brand	Case
Model	680 CK
Category	Front End Loaders
Language	English

Summary

GENERAL ENGINE SPECIFICATIONS

General

Basic engine specs (type, bore, stroke, compression ratio, speeds).

Engine Lubricating System

Fuel System

MAINTENANCE AND LUBRICATION

Maintenance Chart

Intervals and services for machine maintenance.

Fluids and Lubricants

Specifications for machine fluids and lubricants.

TORQUE CHART

U.S. AND METRIC TORQUE SPECIFICATIONS

Torque for bolts, nuts, studs in U.S. and metric.

CYLINDER HEAD AND VALVES

SPECIFICATIONS

INTAKE VALVE

CHECKING COMPRESSION PRESSURE (Continued)

Detailed procedures for engine compression checks.

EXHAUST VALVE

SPECIAL TORQUES

CHECKING COMPRESSION PRESSURE

Procedures for checking engine compression.

TURBO CHARGER SYSTEM

CYLINDER HEAD AND COMPONENTS

Removal

Installation

Inspection

ROCKER ARM ASSEMBLY

CYLINDER HEAD ASSEMBLY

Disassembly

Assembly

INSPECTION OF VALVES, GUIDES, HEAD AND SPRINGS

Inspect Valves for Wear

REFACING INTAKE AND EXHAUST VALVES

Refacing Intake and Exhaust Valves

Procedure and guidelines for refacing valves.

GRINDING INTAKE AND EXHAUST VALVE SEATS

Grinding Intake and Exhaust Valve Seats

Procedures and angles for grinding valve seats.

LOCATING TOP DEAD-CENTER AND TAPPET ADJUSTMENTS

LOCATING TOP DEAD CENTER AND TAPPET ADJUSTMENTS

COLD SETTING

Adjusting tappets at cold temp for 4-cyl engines.

HOT SETTING

Adjusting tappets at hot temp for 4-cyl engines.