1050-2
MAINTENANCE CHART
CAUTION:
The following chart is based on maximum intervals. If the machine operates
in severe conditions, service more often.
INTERVAL
SERVICE
INSTRUCTIONS
Run-In: Every
Check wheel nut and bolt torque.
Two Hours Front - 170 foot-pounds torque.
Until Stabilized
Rear - 220-240 foot-pounds torque.
Check rear axle mounting bolts.
380-460 foot-pounds torque.
Run-In: After Change engine crankcase oil.
First 20 Hours
Replace engine oil filter.
Section 25.
Check drive belt tension.
Section 8016.
Service fuel system.
Section 31.
Every 10 Hours Grease loader pivot points.
or Daily - Which-
ever Occurs Grease backhoe pivot points.
First
Check engine crankcase oil level.
Check hydraulic oil level.
Check radiator coolant level.
Clean air cleaner dust cup.
Visually inspect transfer pump sedimant
bowl for water.
If
found, drain water from
bowl, first stage filter and fuel tank.
Check machine and ground under it for leaks.
Every 50 Hours
Grease front axle pivot.
or Weekly -
Whichever
Grease steering cylinders.
Occurs First
Grease brake shafts and slack adjusters.
Grease inner Extendahoe dipper.
Check tire pressures.
Every 100 Hours Check battery electrolyte level.
Section
8014.
Check drive belt tension.
Section 8016.
Every 150 Hours Change engine oil.
Find manuals at https://best-manuals.com
To Next Page
Loading...
