1050-3
INTERVAL SERVICE
INSTRUCTIONS
Every 250 Hours
Grease driveshaft universals and slip
splines
Grease loader and backhoe control lever
fittings.
Lubricate shuttle control lever.
Check power shuttle/torque converter oil
level.
Check synchromesh transmission oil level.
Check rear axle oil level. Section
6020.
Clean alcohol evaporator filter.
Section
7020.
Every 300 Hours
Replace engine oil filter.
Section
25.
Every 500 Hours
Drain deposits from fuel tank.
Change fuel filters.
Section
31.
Service electric fuel pump and transfer pump
filters.
Section
31.
Repack front wheel bearings.
Check ROPS as indicated. Section
9019.
Every 1000
Change hydraulic reservoir.
Hours or
Yearly, Which-
Replace hydraulic oil filter.
ever Occurs
First
Clean hydraulic filter by-pass screen.
Change power shuttle/torque converter oil.
Clean power shuttle/torque converter screen.
Change synchromesh transmission oil.
Change rear axle oil.
Section
6020.
Clean air compressor cylinder head
(by dealer only).
Every
2000
Disassemble and clean alcohol evaporator.
Hours or (by dealer only).
Section
7020,
Yearly, Which-
ever Occurs Lubricate starter motor.
Section
8015.
First.
Drain, flush and refill cooling system.
Find manuals at https://best-manuals.com
To Next Page
Loading...
