1001-3
SAFETY
This symbol means ATTENTION! BECOME ALERT! YOUR SAFETY
IS INVOLVED. The message that follows the symbol contains
& important information about safety. Carefully read the message.
Make sure you fully understand the causes of possible injury or
death.
To prevent injury always follow the Warning,
Caution and Danger notes in this section and
throughout the manual.
Put the warning tag shown below on the key for the
key switch when servicing or repairing the machine.
One warning tag is supplied with each machine.
Additional tags Part Number 331-4614 are
available from your service parts supplier.
•
DO NOT
OPERATE
Reason ___ _
•
See Other Side
c,s~ P;tro: "4o Pront'1:l In
USA
WARNING: Read the operators manual to
& familiarize yourself with the correct
control functions.
WARNING: Operate the machine and
~
equipment controls from the seat
~
position only. Any other method could
result in serious injury.
~
WARNING: This is one a man machine, no
~
riders allowed.
Don 8-86531
WARNING: Before starting engine, study
Operator's Manual safety messages.
Read all safety signs on machine. Clear
the area of other persons. Learn and
practice safe use of controls before
~
operating.
~
It is your responsibility to understand and
follow manufacturers instructions on
machine operation, service, and to
observe pertinent laws and regulations .
Operator's and Service Manuals may be
obtained from you J.J.Case dealer.
WARNING: If you wear clothing that is too
loose or do not use the correct safety
equipment for your job, you can be
&
injured. Always wear clothing that will not
catch on objects. Extra safety equipment
•
that can be required includes hard hat,
safety shoes, ear protection, eye or face
protection, heavy gloves and reflector
clothing.
WARNING: When working in the area of
~
the fan belt with the engine running, avoid
~
loose clothing if possible, and use
extreme caution.
WARNING: When doing checks and tests
~
on the equipment hydraulics, follow the
~
procedures as they are written. DO NOT
change the procedure.
WARNING: When putting the hydraulic
cylinders on this machine through the
& necessary cycles to check operation or to
remove air from a circuit, make sure all
people are out of the way.
Issued 3-96
Find manuals at https://best-manuals.com
To Next Page
Loading...
