Case Cross - Assembly Instructions; Step 1: Leg Section Assembly; Step 2: Attaching Legs to Table Top

Assembly Instructions
Required
A x 8
B x 4
C x 4
D x 4
E x 4
A
D
A
E
FF
B
C
F x 1
Step 1. Assemble the leg section together by
screwing in tting D into both sides of the
centre leg making sure the hole through the
centre of the tting D is facing towards the top.
place in the dowels (tting A) and take one of the
1/2 leg sections, insert tting E into the top and
bottom of the leg ensuring the clearance holes
are aligned. Attach the legs and tighten tting E,
repeat for the remaining leg.
Step 2. Place the four remaining dowels (tting A)
into the holes in the underside of the table top
as shown above. With help carefully place the leg
section onto the table top aligning with the dowels.
Insert tting B and C into the relevant holes and
fully tighten.
With help carefully turn the table over.